Connect - Communicate - Create
All Discussions Tagged 'hammer' (1)
| Discussions | Replies | Latest Activity |
|---|---|---|
Stakes n HammersLooking for used raising stakes and hammers - low dome stake and sinusoidal stakes especially. Also interested in swage blocks, hardies a... Started by Marnie Astley |
7 |
1 hour ago Reply by David Robertson |
NOTICES
2013 SNAG Conference in Toronto
The Society of North American Goldsmiths (SNAG) 2013 Conference is officially scheduled to take place in Toronto, Canada in May 2013... Read more
Copyright ©2009
Legal Notice Copyright & Trademark Notices
All materials on this Website (the "Site"), and the Site itself are protected by copyrights, trademarks and/or other intellectual property rights. These materials are owned by The Metal Arts Guild of Canada ("MAGC") or by the artists who created these materials. View Full Copyright Notice
The Metal Arts Guild of Canada would like to recognize the support of The Ontario Arts Council for our biennial juried show MAG-2067 "MAG-2067 Crafting the Future"
Forum
Stakes n Hammers 7 Replies
Looking for used raising stakes and hammers - low dome stake and sinusoidal stakes especially. Also interested in swage blocks, hardies and small anvil around 125 pounds
Tagged: silversmith, metalsmith, sinusoidal, hammer, stake
Started by Marnie Astley in Questions anyone?. Last reply by David Robertson 1 hour ago.
Used tools from reliable sources
I have been searching high and low for used equipment or reasonable new. Just starting out and setting up a studio in my garage. I have been after a rolling mill and flex shaft as well as smaller h...
Started by Angie Doran in Questions anyone? Nov 23.
Looking for chasing tools in Canada 5 Replies
I am looking to purchase some chasing tools and quality pitch. I am wondering if anyone knows of is a good supplier near Toronto or at least in Canada. Any help would be greatly appreciated.
Started by Rob Lardie in Questions anyone?. Last reply by Lissa Nov 22.
Copper Repair Request
I received the following message sent to the editor @ metalartsguild.ca. If you can help this lady out, please send me a PM or post on my page, and I'll forward her contact info. To: Dianne King B...
Tagged: enamel, commission, repair, copper
Started by Dianne Karg Baron in Questions anyone? Nov 20.
© 2009 Created by MAG Tech Support
